Your water heater is one of the used and more appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and costs.
Regular flushing of your water heater is considered the single most important step you can take to prolong its service life and to save energy. During time, sediments build up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most involving the country, the common water heater lasts 3-5 years. Regularly flushing your water heater can double living of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is in today’s weather. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.
To drain your water heater, you can find should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to drinking water heater. Next, close the water supply valve located more than a water inlet line going into your water heater. Then you’re connect a hose to the drain valve located at the bottom of the hot water heater. Open the drain and allow it to play until all for the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until drinking water flows out quickly. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in place to discuss options and products to be fitting.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610